My advice is to first enter the I/O (copy names from schematic)in the symbol table, that makes it easier to follow the program, then step by step enter more comments.
Siemens simatic s7 200 troubleshooting full#
This program is full off Jumps and not documentated (upload) so not easy to follow without the machine.
![siemens simatic s7-200 troubleshooting siemens simatic s7-200 troubleshooting](https://1.bp.blogspot.com/-eS0m8mn5H6Y/Xy6IstyokzI/AAAAAAAAAlY/BDLo3jAu4JYfVzIzd_9_HTMGsrrTYteCgCLcBGAsYHQ/s2048/siemens%2Bplc-01.jpg)
So go online an watch what's happening is the best way to check this problem. The outputs are set in the same SBR29 NW 31 and 33, check the conditions for Jump to label 7 and 8. Automation Technology Automation Systems Industrial Automation Systems SIMATIC PLC Basic Controller S7-200 SMART Rate entry. NW45, check V105.2 and the Jump to label 11(NW28) Associated product(s) Edition: System Manual. NW 43, look at the Jump to label 10(NW29) NW 38, if it's reset here look at Jump to label 9.(NW29) Once the Siemens HMI repair is complete, the SIMATIC HMI unit is fully tested again to confirm all functionality and connectivity to the PLC. NW 35, check for Timer 252, if this timer is started look at Jump to label 8 (NW29) SBR 57 is not writing to the output only reading.
![siemens simatic s7-200 troubleshooting siemens simatic s7-200 troubleshooting](https://cdn.cupdf.com/img/1200x630/reader018/reader/2020011218/547ff4b25906b5ea288b469d/r-1.jpg)
I had the idea to replace Q2.5 by Q2.3 and transfer the program to the plc but I’m afraid to do it because the program will be erased and the machine will be down.įirst check your output online in a table, if it's 1 in the table and led and physical output still 0 then your output is defect.īut i suspect some off the conditions to reset the output is 1 in the program. Please can someone explain me:ġ- what SBR57 (on picture1) instruction refers to and what are the meaning of the different inputs and outputsĢ- I face problems when uploading to these CN plcs because at the end of download I get prompt talking about “compile error”, while the program is compiled without any error
![siemens simatic s7-200 troubleshooting siemens simatic s7-200 troubleshooting](https://images-na.ssl-images-amazon.com/images/I/31n3450g+KS._SX258_BO1,204,203,200_.jpg)
Siemens simatic s7 200 troubleshooting manual#
I've compared with another output (ie 2.6) which work fine.Running through the program (cross reference), these 2 outputs have the same instructions sets.Refer to the attached files above.I don't understand why it work for Q2.6 and not for Q2.5 as they have the same instructions set. Preview the Siemens Simatic S7 200 Manual Your Siemens Simatic S7 200 Manual is loading below, it should show up in a few seconds, depending on your connection. (the led is off and no 24V output to the relay connected on it) I have a S7 200 CN CPU 226 and the Output Q2.5 don't activate when I send command on the panel.